====== SDCC Installation for PIC micro Controller ======

===== Installation and source folder =====

In this example every source will be downloaded and compiled in 
<code>/opt/bleeding_edge/</code>
so this path must be adjusted to the path you used.

All supplied configure options are for installations to
<code>/usr/local/</code>
if you want an other installation folder, mostly --prefix="/path/to/destination/folder/" could be used.


==== gputils ====

change directory
<code>cd /opt/bleeding_edge</code>

get the newest gputils code
<code>svn checkout svn://svn.code.sf.net/p/gputils/code/trunk gputils_svn_trunk</code>

change to the newly checked out code repository
<code>cd gputils_svn_trunk/gputils</code>

configure the project (with disabled html-doc and faster "one-time"-build)
<code>./configure --disable-html-doc --disable-dependency-tracking</code>

compile and install everything
<code>
make
sudo make install
</code>



==== sdcc ====

change directory
<code>cd /opt/bleeding_edge</code>

get the newest sdcc code
<code>svn checkout svn://svn.code.sf.net/p/sdcc/code/trunk/sdcc sdcc_svn_trunk</code>

change to the newly checked out code repository
<code>cd sdcc_svn_trunk</code>

configure the project (only PIC14 and PIC16 enabled)
<code>
./configure --disable-mcs51-port --disable-z180-port --disable-z80-port --disable-r2k-port --disable-r3ka-port --disable-gbz80-port --disable-tlcs90-port --disable-ds390-port --disable-ds400-port --disable-hc08-port --disable-s08-port --disable-stm8-port
</code>

compile and install everything
<code>
make
sudo make install
</code>